Create Multiple Load Sets on Single Node

[gmeazza]

Hello All,

I had a question on creating multiple loads sets on a single node. I have an angle modeled and would like to see how it reacts at 5 deg angle increments with a 1000# load at a singular node (represents a tie rod attachment)

So, is there a way to input these load sets by possibly a table or something that doesnt require inputting each x,z load case individually?

Thanks
GMeazza

 

[rb1957]

you could use co-ord systems,

but all you're doing is calcing co-ord systems rather than load components ....
and how hard is it to do that ?

Quando Omni Flunkus Moritati