Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

COSMOSWorks 2009 Chart Options

Status
Not open for further replies.
Robbo1971

Robbo1971

Automotive
Joined
Nov 1, 2006
Messages
33
Location
GB

When calculation the 'stress' of a part... our Company standard is to calculate the stress at 60% of the yeild!

Is there a way of showing this on the chart as well as indicating the 'Yeild strength' which is shown as standard?
 
Sort by date Sort by votes
You could set the maximum on your chart to the 60% yield value. Everything exceeding this will be shown in red.
 
Upvote 0 Downvote
yes, that is what I have done... but ideally I would like to show both the 'Yeild' and the '60% of Yeild'!
 
Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

var10
  • Locked
  • Question Question
Can I use Cosmosworks for Vibration testing?
Replies
0
Views
132
var10
var10
ptruitt
  • Locked
  • Question Question
New Y14.5-2009 & Y14.8 symbols for Solidworks 2009?
Replies
1
Views
113
kellnerp
kellnerp
Mechanimal
  • Locked
  • Question Question
2008 - Cosmosworks Thermal model
Replies
1
Views
137
kellnerp
kellnerp
mikito
  • Locked
  • Question Question
Modeling Half-Sine Shock Load in Cosmosworks
Replies
1
Views
178
bnrg
bnrg
rrray47
  • Locked
  • Question Question
Analysis of PVC Pipe_Joint using CosmosWorks 2005
Replies
2
Views
146
kellnerp
kellnerp

Part and Inventory Search

Sponsor

Back
Top