Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations JAE on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

2008 - Cosmosworks Thermal model

Status
Not open for further replies.
Mechanimal

Mechanimal

Mechanical
Joined
Oct 16, 2006
Messages
42
Location
CA
Hi,

I am running a thermal / stress model and have noticed that the displacement from thermal movement in the stress analysis isn't from my fixed point. The program seems to assume it is at the base of the model instead of where I have the fixed support. I am wondering if this is something that you can possibly change in the thermal model?

Thanks,
Animal
 
Sort by date Sort by votes
Status
Not open for further replies.

Similar threads

oharag11
  • Locked
  • Question Question
Error - Please enter a value greater than 0 - Thermal Joint?
Replies
0
Views
980
oharag11
oharag11
seraph3333
  • Locked
  • Question Question
IR LED solidworks thermal simulation unexpected extreme low temperature problem
Replies
2
Views
322
seraph3333
seraph3333
Anurag K
  • Locked
  • Question Question
Modeling clamping effect in SolidWorks FEA
Replies
2
Views
1K
FEA way
FEA way
Denny Gibson
  • Locked
  • Question Question
SolidWorks 2018 Simulation: Simultaneous solution of mechanical and thermal stresses?
Replies
1
Views
310
FEA way
FEA way
cdixonm
  • Locked
  • Question Question
Linear Dynamic Model doing a harmonic study measuring relative displacement between two points
Replies
2
Views
317
cdixonm
cdixonm

Part and Inventory Search

Sponsor

Back
Top