Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Corrosion boiler Stacker

Status
Not open for further replies.

gertv

Industrial
Joined
May 16, 2010
Messages
5
Location
ZA
Good day,

Looking for a product for which a boiler Stacker (inside) can be applied and also holds? Against corrosion, but it must be able to withstand higher temperatures as indicated on the data sheet, namely 350 ° C-400 ° C. And, it should be fully cured within 12 hours, so that the boiler can be restarted. The Ausfall-/Standzeit of the boiler is 12 hours ...
The product should brush - or even spray application. Most likely, only a 2-component product comes into question and must be preheated and then therefore can only be applied by spraying.
The surface to be treated is a total of only 15sqm.

Regards,

Gert.
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top