Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations LittleInch on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Correct way to write the hole size

Status
Not open for further replies.
Status
Not open for further replies.

Similar threads

F
  • Question Question
Use the Drawing title block linear tolerance to control a Diametrical callout size - is it correct?
Replies
3
Views
2K
Burunduk
Burunduk
supergee
  • Locked
  • Question Question
threaded hole depth feature of size?
Replies
16
Views
6K
Burunduk
Burunduk
A
  • Question Question
Shaft can't fit in the hole.
2
Replies
27
Views
4K
juergenwt
juergenwt
B
  • Question Question
How to measure hole diameter?
2
Replies
22
Views
2K
Burunduk
Burunduk
rollingcloud
  • Locked
  • Question Question
Is my understand of the FRTZF correct?
Replies
7
Views
5K
rollingcloud
rollingcloud

Part and Inventory Search

Sponsor

Back
Top