lenthezhongwen
Industrial
Where is the "core tube" on a valve and the "wire connectors". I have a supplier that are sending these parts of the valve loose and not tight enough. Hope this makes sense.
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations JAE on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Core Tube and Wire Connector
- Thread starter lenthezhongwen
- Start date
- Status
MikeHalloran
Mechanical
It would probably make sense to someone who has the valve on their desk, or maybe a cut sheet for the valve, but since you didn't even come close to identifying the actual valve, we probably can't help much.
Mike Halloran
Pembroke Pines, FL, USA
Mike Halloran
Pembroke Pines, FL, USA
- Thread starter
- #3
hydroman247
Mechanical
The core tube is the metal tube in the centre of the coil. Remove the plastic screw on the end, slide off the coil and there is the core tube. They usually screw into the main valve body or are clamped on with bolts.
- Status
Similar threads
- Locked
- Question
- Locked
- Question