Copy sequence from One Assembly to Another Assembly - NX 9.0.3.4 MP2

[mathisudar2007]

Hello,

Is it possible to copy / paste the 'sequence' from one assembly file to another Assembly file?

The design intent - copy and paste the motion steps and re-link the components with the motion steps.


Thanks,

Mathi K

 

[JohnRBaker]

Not that I'm aware of. You might be able to take the part with the desired sequence, do a 'Save-As', replace the Components and then go into Sequencing and assign the new Components to the old steps (note that I've never tried this nor have I heard of anyone else doing so, therefore this is pure speculation on my part).

John R. Baker, P.E.
Product 'Evangelist'
Product Engineering Software
Siemens PLM Software Inc.
Digital Factory
Cypress, CA
Siemens PLM:
UG/NX Museum:

To an Engineer, the glass is twice as big as it needs to be.