S
sarveshs
Guest
View attachment 952
HELLO ALL GROUP MEMBERS
I AM TRYING TO CREATE MECHANISM OF A LOCK. I HAVE CREATED TO PARTS CALLED CHASIS AND BOLT AS SHOWN IN FIG. I CONNECT THEM WITH THE SLIDER JOINT SO THAT I CAN SIMULATE THE MECHANSIM AND HENCE THE THROW.
I HAVE ONE QUESTION. THE FACE OF THE BOLT SHOULD BE 22MM FROM THE FACE OF THE CHASIS.BUT THE BOLT CAN COME BACKWORD. SO HOW CAN I PROVIDE THIS DIAMESIONAL CONSTRAINT ON THE FACE AND CREAT EHT MEHCANISM.
THANKING YOU,
WITH REGARDS,
S.SHANISHCHAR
HELLO ALL GROUP MEMBERS
I AM TRYING TO CREATE MECHANISM OF A LOCK. I HAVE CREATED TO PARTS CALLED CHASIS AND BOLT AS SHOWN IN FIG. I CONNECT THEM WITH THE SLIDER JOINT SO THAT I CAN SIMULATE THE MECHANSIM AND HENCE THE THROW.
I HAVE ONE QUESTION. THE FACE OF THE BOLT SHOULD BE 22MM FROM THE FACE OF THE CHASIS.BUT THE BOLT CAN COME BACKWORD. SO HOW CAN I PROVIDE THIS DIAMESIONAL CONSTRAINT ON THE FACE AND CREAT EHT MEHCANISM.
THANKING YOU,
WITH REGARDS,
S.SHANISHCHAR
