Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Conical or rotated profile in sheetmetal
- Thread starter asimpson
- Start date
beachcomber
Mechanical
You need to use a Lofted Flange for this.
The two ends of the cone will be the 2 profiles.
I would create them as sketches first, and make sure there is a break at the same point on each circle.
bc.
2.4GHz Core2 Quad, 4GB RAM,
Quadro FX4600.
Where would we be without sat-nav?
The two ends of the cone will be the 2 profiles.
I would create them as sketches first, and make sure there is a break at the same point on each circle.
bc.
2.4GHz Core2 Quad, 4GB RAM,
Quadro FX4600.
Where would we be without sat-nav?
- Thread starter
- #3
beachcomber
Mechanical
There are also Options settings for triangulation of segments such as you would use for a square to round transition.
If you do a square to round, its best done in quarters, so that you can map vertices correctly.
bc.
2.4GHz Core2 Quad, 4GB RAM,
Quadro FX4600.
Where would we be without sat-nav?
If you do a square to round, its best done in quarters, so that you can map vertices correctly.
bc.
2.4GHz Core2 Quad, 4GB RAM,
Quadro FX4600.
Where would we be without sat-nav?
- Status
Similar threads