Conic surface and n-sided patch

[annad_m_s]

There used be an option to create boundary blended surface with more than 4 boundaries using Conic Surface and n-sided patch option in earlier version of Creo and Pro/e. However, I could not see such option available in Creo 3.0. Can anyone tell me where is option is available in Creo 3.0?

Thanks and regards,

Ananda Kumar

 

[tobbo]

https://www.quora.com/Where-is-the-conic-surface-and-n-sided-patch-command-in-Creo-PTC-3-0

Doug Schaefer wrote :

You need to add the config option:
enable_obsoleted_features yes
Then if you search for "patch" in the command search, it will show up.



//Tobias

 

[tobbo]

I personally would prefer using style if i would have to do a n sided surf ;-)

 

[annad_m_s]

I thank you Tobias wholeheartedly for taking all the trouble to answer my query. Unfortunately I do not have the required license for ISDX. Hence, I need to be satisfied with whatever available with the standard version.