Conflicted item in sketch

[DrBwts]

I have an Item Conflict in the attached sketch (SW 2014). I have deleted all constraints & relationships but still I cant resolve one of the points in the sketch.

Anybody any idea how to resolve this without a complete redraw?

Thanks

http://files.engineering.com/getfil...-abb7-3aa4426c62f5&file=ConflictIssues.SLDPRT

 

[CorBlimeyLimey]

Take a closer look inside the circled areas.

 

[DrBwts]

Thanks I've managed to clear up most of those but there is 1 point that I still cant get to resolve.

No matter how far I zoom in I cant see the issue.

 

[djhurayt]

when I zoom into that last area i see this

 

[TheTick]

I would probably do something like this in two sketches: first a layout and then a final detail. The layout would have complete circles instead of broken concentric circles. I think the solver is getting taxed by the multiple coradial circles and close endpoints. Then the detail would be constrained to the layout.

 

[DrBwts]

I found it I couldnt see due to the contrast on the monitor. Yellow on white not so good for my eyes.

Thanks CorBlimeyLimey

 

[SBaugh]

haha, wait till you go to 2016 its worse when it comes to color and contrast.

Scott Baugh, CSWP
Gryphon Environmental

http://www.2gryphon.com

"If it's not broke, Don't fix it!"

faq731-376