Configuration specific material in drawings

[MechThermDesigner]

Hello All,

I have a part with 2 configurations which are set with specific materials. When im creating a drawing I cant get the material to be configuration specific. The material changes to the last active configuration. Is there any way to make it configuration specific?

Cheers

 

[CorBlimeyLimey]

Are you right mouse clicking on the view and selecting Properties > Use named configuration as shown?

 

[MechThermDesigner]

Yes, and all the views are set to the same configuration.

 

[CorBlimeyLimey]

It works for me, but I have to hit the Rebuild button? Or select the view and Ctrl Q.

 

[MechThermDesigner]

That only works when you have the same configuration active in the model and drawing. But when in the other configuration in the part, hit ctrl Q it changes to the other material. This shouldn't happen.

By the way im using SW09 SP01

 

[CorBlimeyLimey]

Nope ... I can change config in any drawing view no matter which config is active in the model.

 

[MechThermDesigner]

I had the solid solutions guy have a look at it and he couldnt figure out why this was happening.