Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Company name change 1

Status
Not open for further replies.

tloutzen

Aerospace
Joined
Jan 7, 2004
Messages
6
Location
US
We are officially changing our company name (company was sold) in November. The question - is it necessary (or proper) to update drawings and technical documents approved and released under the old operating identity to reflect the new company name? We are not going to write change orders just to update the name, but our Change Management group and Tech Writing group plans to change all references on drawings on documents from the old company name to the new name when there is a change request against the document for other reasons.
Thanks!
 
That is how we have proceded. Whenever a new document is created or an existing one is revised, the new company info replaces the old. No problems (so far).
 
Agree with ewh, probably the most sensible way to go.

KENAT, probably the least qualified checker you'll ever meet...
 
Also remember to update all of your company specs, documents, etc, with the new name and logo.

Also, the company "paper pad", mugs, pens, golf shirts, golf balls, etc, will need updating too.

"Do not worry about your problems with mathematics, I assure you mine are far greater."
Albert Einstein
Have you read FAQ731-376 to make the best use of Eng-Tips Forums?
 
You may want to look at ASME Y14.100 section 6 as it kind of covers this, perhaps 14.35 too.

KENAT, probably the least qualified checker you'll ever meet...
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top