Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations MintJulep on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

COMBINING DRAWINGS

  • Thread starter Thread starter mkay
  • Start date Start date
Status
Not open for further replies.
M

mkay

Guest
Hey everyone!


This is my first post to the forum....so just let me say "thanks" in advance....





My question is as follows...I have a project that includes several different drawings on separate files. Is there any way possible I can combine these different files into one multi-sheet drawing with out havenig to redraw everything? The total number of files involved is around 13, so redrawing would be very time consuming.
smiley18.gif



Thanks again
 
You could add several sheets to your assembly drawing and then just
copy and paste each legacy part drawing views into each new sheet.
 
Status
Not open for further replies.

Similar threads

LeRepeteur
  • Locked
  • Question Question
PDM Question - FileVault and Save As of Drawings and Assemblies
Replies
11
Views
1K
drawoh
drawoh
plutoniumsalmon
  • Locked
  • Question Question
Oblique projection in Solidworks drawings questions
Replies
4
Views
823
3DDave
3DDave
kaffy
  • Locked
  • Question Question
Regarding Sheet metal drawings
Replies
10
Views
639
kaffy
kaffy
rothers
  • Locked
  • Question Question
Lightweight Drawings
Replies
6
Views
523
SBaugh
SBaugh
borsht
  • Locked
  • Question Question
Drawings-is there a scale factor for line styles?
Replies
0
Views
184
borsht
borsht

Part and Inventory Search

Sponsor

Back
Top