Hello everyone,
I got one single sheet body made of several surfaces which is very good for me like first attachment. But I have to transformed into .iges or .step file in order to import into Abaqus to run a simulation. But when I did this, the quality turned out very bad shown in the second attachment. Could someone please help me to combine the surfaces? These surfaces are combined automatically into single body. But when I saved as another type of file, it was not. Thank you ! The version I am using is 9.0.
Best regards.
I got one single sheet body made of several surfaces which is very good for me like first attachment. But I have to transformed into .iges or .step file in order to import into Abaqus to run a simulation. But when I did this, the quality turned out very bad shown in the second attachment. Could someone please help me to combine the surfaces? These surfaces are combined automatically into single body. But when I saved as another type of file, it was not. Thank you ! The version I am using is 9.0.
Best regards.
