VABiker
Mechanical
- Jul 18, 2011
- 19
Wondering how other folks handle this in SE (ST4), when you have multiple circular arc segments that all have the same radius, sharing the same center point?
SolidWorks has a "co-radial" constraint, which is pretty nice.
In SE, I create a radial construction line from the circular arc center to the midpoint of the circular arc, then make those lines equal in length.
It works well enough, but I had an instance with a lot of co-radial arc segments, so it got to be a bit annoying doing the same construction repeatedly.
SolidWorks has a "co-radial" constraint, which is pretty nice.
In SE, I create a radial construction line from the circular arc center to the midpoint of the circular arc, then make those lines equal in length.
It works well enough, but I had an instance with a lot of co-radial arc segments, so it got to be a bit annoying doing the same construction repeatedly.