Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations JAE on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Clear Zone Question

Status
Not open for further replies.

gbam

Civil/Environmental
Joined
Jan 20, 2003
Messages
880
Location
US
Is there a ref. on clear zones for curbed sections? I have looked and looked but cannot find any. Your help is greatly appreciated.
 
IS THIS FOR HANDICAPED RAMPS?
 
No. We in our office have always applied the typical clearzone concept per the Roadside Design Guide. However, we cannot find any info on an urban curbed section. We are working on a DCR for stretch of roadway that is mostly rural now but expected to be urban in a few years. I am trying to set drop inlets and culverts so that the ends are safely outside of the clearzone.
 
My understanding is that clear zones and their slopes are for vehicle recovery from the main lane. A curb is meant to prevent a vehicle from going off the road for certain speeds, so a clear zone should not apply there.

Regards

VOD
 
I agree VOD, however, we are only dealing with a 6" reveal for this curb. Also there is no distinction on wether this type of curb is a barrier curb or is mountable.
 
Check with the city or municipality wrt setbacks for right of ways and utilities.

VOD
 

If possible, the normal clear zone should be provided.

Clear zones will not redirect a vehicle, except for low speed, low angles impacts. The Greeen Book lists offsets for street furniture, luminaires, etc, but this is mostly so truck mirrors don't hit them, and people can open car doors.

Curbs should not be used on higher speed roads. Vehicles ten to vault at higher speeds.

------------------------------------------
"Come to think of it, there are already a million monkeys typing on a million typewriters, and the Usenet is NOTHING like Shakespeare.

Blair Houghton
 
Typically, we have been using the standard clear zone distances. It seems that the smart thing is to continue using the full distance. Thank you all for your input!
 
Actrafficengr - At what speed would a vehicle "vault" for a 6 or 8 inch curb?
 
Even at lower speeds, a vehicle will climb a curb. As speeds increase, the curb can throw the car upwards. At 80 km/h and above, a vehicle can actually clear a guiderail.

It's a bit complicated to go into detail here - depends on curb type, guiderail type, distance between rail and curb, etc. See the AASHTO Roadside Design Guide or your state DOT/MOT's design manual for more info.

------------------------------------------
"Come to think of it, there are already a million monkeys typing on a million typewriters, and the Usenet is NOTHING like Shakespeare.

Blair Houghton
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top