Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Changing the size of angle projection symbol
- Thread starter SethT
- Start date
- Thread starter
- #2
cubalibre000
Mechanical
If the idea to change the size to put in the title block, the response is not possible.
As you can see the Siemens template, this symbol reside outside the title block.
Thank you...
Using NX 8 and PDM RuleDesigner
As you can see the Siemens template, this symbol reside outside the title block.
Thank you...
Using NX 8 and PDM RuleDesigner
- Status
Similar threads