Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Changing Chart Options

Status
Not open for further replies.
sloth4z

sloth4z

Mechanical
Joined
Aug 12, 2003
Messages
132
Location
US
I am looking at a Design Check plot. When I go into Chart Options to change the scale to a defined scale, the change is only temporary. After I change plots and reopen the original plot, the changes are removed. How do I get the changes to "set in".

I am using SW2006 SP4.1, and CosmosWorks 2006 SP4.0.
 
Status
Not open for further replies.

Similar threads

robbo13
  • Locked
  • Question Question
Changing temporary directories in COSMOS
Replies
3
Views
202
kellnerp
kellnerp
Robbo1971
  • Locked
  • Question Question
COSMOSWorks 2009 Chart Options
Replies
4
Views
163
kellnerp
kellnerp
Dundorf
  • Locked
  • Question Question
How does SW Sim/Comos respond to changing contact areas?
Replies
1
Views
151
kellnerp
kellnerp
sloth4z
  • Locked
  • Question Question
Chart Options
Replies
0
Views
111
sloth4z
sloth4z
sloth4z
  • Locked
  • Question Question
Design Scenario not changing values
Replies
1
Views
189
sloth4z
sloth4z

Part and Inventory Search

Sponsor

Back
Top