Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations MintJulep on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

centreline to outside radius dimension

Status
Not open for further replies.

G1DESIGN

Bioengineer
Joined
Feb 28, 2003
Messages
152
Location
GB
can anyone tell me how to dimension a diameter using a centreline to outside radius in inventor i cant get it to work
it is constantly going back to the ctr point of the rad

thanks mike
 
In what mode? In IV 9 in part /sketch mode you can dimension a radius by clicking on the circle and then right-clicking the mouse and selecting radius.
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top