Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Center og gravity - NX 8.5
- Thread starter bbeer
- Start date
Have a look at
Best regards,
Michaël.
NX7.5.4.4 + TC Unified 8.3
Win 7 64 bit
Best regards,
Michaël.
NX7.5.4.4 + TC Unified 8.3
Win 7 64 bit
JohnRBaker
Mechanical
As stated in the above referenced link, just use the...
Analysis -> Measure Bodies...
...function and if you toggle ON the 'Associative' option, there will be a point created at the centroid (Mass Center) of the selected solid body. Optionally you can also have the system create a Coordinate System representing the major X,Y,Z principle axis.
John R. Baker, P.E.
Product 'Evangelist'
Product Engineering Software
Siemens PLM Software Inc.
Digital Factory
Cypress, CA
Siemens PLM:
UG/NX Museum:
To an Engineer, the glass is twice as big as it needs to be.
Analysis -> Measure Bodies...
...function and if you toggle ON the 'Associative' option, there will be a point created at the centroid (Mass Center) of the selected solid body. Optionally you can also have the system create a Coordinate System representing the major X,Y,Z principle axis.
John R. Baker, P.E.
Product 'Evangelist'
Product Engineering Software
Siemens PLM Software Inc.
Digital Factory
Cypress, CA
Siemens PLM:
UG/NX Museum:
To an Engineer, the glass is twice as big as it needs to be.
- Status
