Cell height in Hole Table

[bigBboris]

I cannot adjus cell height of a Hole Table on a drawing. SW does not let me decrease cell height neither by drag nor by entering number. When I try to type cell height, prompt requires me to enter number greater or equival of what I already have.Table is getting bigger then sheet format.
I am using SW 2004, SP0. Any Ideas?

Boris.

 

[yanceman]

I don't know if it will help, but you can load newer service packs. SP3.0 is available.
Yanceman

 

[SBaugh]

I agree with yanceman - Upgrade to a newer SP

Regards,

Scott Baugh, CSWP
3DVision Technologies

http://www.3dvisiontech.com

http://www.scottjbaugh.com

faq731-376
faq559-716 - SW Fora Users

 

[R1100S]

Solidworks is an ugly b*tch sometimes. If a newer service pack doesn't fix the problem, try opening the table in excel, resizing and reopening it in SW. It's worked for me.

Good luck

 

[bigBboris]

How can I open it in Excel? Where that file is?

 

[CorBlimeyLimey]

R1100S ... I think you are gettting confused with the Excel based BOM. The Hole Table & Rev Table are SW based & although they can be Saved as a TXT or CSV format file, for import into Excel, I know of no way to re-import them back into the SW based tables.


Making the best use of this Forum. faq559-716
How to get answers to your SW questions. faq559-1091
Helpful SW websites every user should be aware of. faq559-520

 

[R1100S]

My mistake, no advice then.