Cast and Mach comp with Inheritance feat.

[SRINIVASANIYER1]

There was a lot of dos and donts regarding the subject some time ago. I thought I would write an article on the same. Since I could not post it. I am posting it under this topic.


2008-03-27_034131_Designing_Cast_and_Machined_component_usin g_Inheritance_feature.ziphttp://www.mcadcentral.com/proe/for...hined_component_using_Inheritance_feature.zip


I would welcome user comments and suggestions to improve.
Edited by: SRINIVASANIYER1

 

[SRINIVASANIYER1]

any comments or suggestions for improvement....?

 

[muadib3d]

looks good, it is appearent to me, how much effort is costed You

After that(an article) I have to rethink my way of creating machined parts - merge or copy geom

Are there any important(not desired) reference impacts? - PDMLINK , Intralink considered

 

[dr_gallup]

I must have missed this when you first posted. I just downloaded & printed it. I'll take a close look when I have the time. Thanks for putting out the effort.

 

[SRINIVASANIYER1]

Thanks David,


Await your reply.


----


muadib3d,


Yes it did take some effort. But in the process, I learnt a lot. This was meant to be a procedure for design for designing cast components. It was mostly in my head communicated down the line thru oral instructions. Thought I might as well document it.

 

[muadib3d]

Some time ago I was also affected by investigation for best way of.... That moment it was also housings related. There have already been company standard providing the core of - what should be included in all models. However it was noticed poeple felt helpess when it comes to make a model within all these standards. So I introduce two projects - one for creating special way oFinaly both were switched to 6 Sigma projects. In the end I moved to another company, and I do not know what is going on about the now

 

[muadib3d]

..So I introduce two projects - one for creating special way o...

of trainings for whole company, second about best modeling appraoch to meet all company demands and make model perspicious for everybody

 

[annad_m_s]

Dear Srini,

Can you re-upload the attachment please? The above given link is no more valid now.