Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

  • Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Can't view numeric values at bottom of the screen

Status
Not open for further replies.

scg101

Civil/Environmental
May 30, 2008
1
US
I am using Microstation 95. Typically, numeric values such as area calculations and line lenghts and bearings are displayed in the grey area at the bottom of the secreen. For some reason thest values are no longer being displayed. Any advice? thanks very much.

Scott
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor