I need to make some modifications to a sketch in NX 8.0 but there is no sketch within the tree. There is only the revolve which is made from a sketch thats in space but is not in "Sketch in Task Environment". Anybody know whats happening here? I've attached screen shots of the revolve & the sketch it was made from.
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations MintJulep on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Can't manipulate sketch in NX 8.0
- Thread starter Jashe
- Start date
- Thread starter
- #2
Wrong forum.
Regards
Fernando
Regards
Fernando
- Status
Similar threads
- Locked
- Question
- Dave P
- DASSAULT: CATIA products