Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

  • Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Can't make diameter dimension go across the circle 1

Status
Not open for further replies.

frankreid

Mechanical
Mar 9, 2007
92
I can't find the place to change the diameter dimension from a small arrow on the outside of a circle to one which also has a line going across to the other side.

Frank Reid
Reid Engineering Services of Utah
 
Replies continue below

Recommended for you

THANKS. THAT DID IT.

Frank Reid
Reid Engineering Services of Utah
 
Or, if you click on the dimension and then right-click, DimText position comes up. take "move text alone" and move it were you want it.
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor