I am using NX5.0.4.1. If I have two models in NX and I can see each one through pulling down the window command and selecting the part. Is it possible to see two separate models each one in a cascaded window? Two windows tiled horizontally in that single NX session ?
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Can I See Two Different UG Parts In Cascaded Windows InOne UG Sessio
- Thread starter jaguar306
- Start date
JohnRBaker
Mechanical
No.
John R. Baker, P.E.
Product 'Evangelist'
NX Design
Siemens PLM Software Inc.
Cypress, CA
To an Engineer, the glass is twice as big as it needs to be.
John R. Baker, P.E.
Product 'Evangelist'
NX Design
Siemens PLM Software Inc.
Cypress, CA
To an Engineer, the glass is twice as big as it needs to be.
P.S. The second session does not consume an additional license so you can open several at no additional cost.
The most common and useful strategy that I employ is to open versions of the same part in different sessions when modelling changes to sequences of features that I might otherwise struggle to follow.
Limitiations may unfortunately apply to users of Teamcenter in that regard.
Cheers
Hudson
The most common and useful strategy that I employ is to open versions of the same part in different sessions when modelling changes to sequences of features that I might otherwise struggle to follow.
Limitiations may unfortunately apply to users of Teamcenter in that regard.
Cheers
Hudson
- Status
Similar threads
- Locked
- Question