can i assign writes to a .prt?

[bcrenwick09]

hi, I am relatively new to Nx. We have been using NX for about 2 years, and we have not yet installed Teamcenter. As of now my files are a mess on a random network drive. Does anyone know if it is possible to assign read/write access to .prt files? Any help would be greatly appreciated.

Thanks

 

[JohnRBaker]

Without Teamcenter your only real choice is to use the normal Windows (or Linux/MacOS) procedures to control ownership as well as the 'read only' status of your NX part files. But if you do, native (non-Teamcenter) NX will fully honor these Windows (or Linux/MacOS) properties.

John R. Baker, P.E.
Product 'Evangelist'
Product Engineering Software
Siemens PLM Software Inc.
Industry Sector
Cypress, CA

http://www.siemens.com/plm

UG/NX Museum:

http://www.plmworld.org/p/cm/ld/fid=209

To an Engineer, the glass is twice as big as it needs to be.

 

[bcrenwick09]

ok, thats what I thought. Thanks for you help

 

[looslib]

I have done this at 2 different companies. Using the search options for loading files from a released directory structure over WIP files or opposite if you are developing models or manufacturing from them.


"Wildfires are dangerous, hard to control, and economically catastrophic."

Ben Loosli