Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

  • Congratulations SE2607 on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

calculation for smoke point for kerosene! 1

Status
Not open for further replies.

checkon

Chemical
Aug 13, 2007
5
Hi every body!
I am a newcomer and I have a problem with smoke point of kerosene when I set up the simulation for a CDU. Any one can help me the method to calculate smoke point of KO? Thank you very much for your help!
Checkon
 
Replies continue below

Recommended for you

Hi checkon,

You can find calculation procedure at API Technical Data Book, Chapter 2 - Characterization of hydrocarbons.
I am not sure if commercial simulators has ability to calculate smoke point.

Regards,

Milutin
 
Thank you very much Milutin.
Right now I haven't got this document, any one can help me to get it free? About smoke point, I just estimate the effect of it to specifications of the modul: temp, pres, ... before set up it!
Thanks,

Checkon
 
It is not possible to get this book for free, it is copyrighted.

Regards,


Milutin
 
Thank you very much.Milutin.
I am very apreciated about your help.
Best regard,

Checkon
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor