Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations JAE on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Bystronic Drives not ready error
- Thread starter Jim 71
- Start date
TheLaserburns
Industrial
You normally get that error after a head collision. Try doing a CNC Reset/restart from in the administrator menu.See if that helps.
If you ask me to do something, I will do it. There's no need to nag me every 6 months
If you ask me to do something, I will do it. There's no need to nag me every 6 months
- Thread starter
- #3
If you found 3 fuses blown in the drives I would shut the machine down and thoroughly blow out the cabinet and drives with air. I see them arc over internally all the time from laser dust buildup. VERY IMPORTANT!- do not blow out the electronics while the power is on!
Chris Krug Maximum Up-time, Minimum BS
Chris Krug Maximum Up-time, Minimum BS
- Thread starter
- #5
Hi Krugtech,
I did find the fuses blown .Have changed them all is working now.I have not commissioned the machine yet I will get technician to do the final once over. I am trying to get as much done on my own.Next question when I turn the chiiler on ,on a hot day I get a high pressure alarm (3)comes on ,but when I start it in the morning all is fine.
I did find the fuses blown .Have changed them all is working now.I have not commissioned the machine yet I will get technician to do the final once over. I am trying to get as much done on my own.Next question when I turn the chiiler on ,on a hot day I get a high pressure alarm (3)comes on ,but when I start it in the morning all is fine.
low air flow usually, look for bad fans and a dust clogged condenser
Chris Krug Maximum Up-time, Minimum BS
Chris Krug Maximum Up-time, Minimum BS
- Status
Similar threads