redandysafc
Mechanical
Can anybody tell me in Bs 4871 pt 1 when I get Charpy's done for the welders test piece do I have to take the samples from FL,FL+2,FL=5 AND HAZ.
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
BS 4871 pt 1
- Thread starter redandysafc
- Start date
- Status
- Thread starter
- #2
andyenergy
Materials
BS 4871 Part1 was superseded by BS EN 287-1: 1992.
There is/was no requirement for mechanical testing of welders test pieces, only for weld procedure qualification, which is covered by EN ISO 15614-1:2004.
This details test pieces , locations of test samples and the conditions under which impact tests are required. You need to get hold of copies of these standards.
There is/was no requirement for mechanical testing of welders test pieces, only for weld procedure qualification, which is covered by EN ISO 15614-1:2004.
This details test pieces , locations of test samples and the conditions under which impact tests are required. You need to get hold of copies of these standards.
- Thread starter
- #4
- Status
Similar threads
- Locked
- Question