broken broke view!

[gatnact]

I have this problem when I use the broken view function. After applying it to a part or parts, when I rebuild, the function seems to no longer be applied to the part in which was applied to. Sometimes I am using a second sheet and if I print then the not so broken views seem to extend past the printable area and cover up other details and views. HELP!!!

 

[CorBlimeyLimey]

Which version and SP of SolidWorks?

Are you only having problems when printing?
Can you update the printer driver?

 

[Regg]

Does it happen all the time. I have seen this but not on a regular basis. Service pack 4.0 also did something to broken views. We have a couple drawings where you must go to the model and rebuild it before the broken view will work correctly in the drawing. I will assume that this will not work for you since it makes no sense in the first place.

Regards,

Regg

 

[wes616]

I remember something about this as a bug in 2005. It was specifically limited to multi sheet drawings. Other than that I don't remember what the solution was.

Wes C.
------------------------------
No trees were killed in the sending of this message, but a large number of electrons were terribly inconvenienced.