luckysever
Industrial
Hello! Maybe I'm bad looking at the NX 9 or promised broaching body rotation, as in the SW has not added? And, if not added, then whether it appeared in the NX 10?
And it makesSW
And it makesSW
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Broaching body NX 9 or NX 10.
- Thread starter luckysever
- Start date
- Status
JohnRBaker
Mechanical
If you're referring to the so-called 'Swept Volume' function, that has been delayed, perhaps to the next version of NX (after NX 10.0).
John R. Baker, P.E.
Product 'Evangelist'
Product Engineering Software
Siemens PLM Software Inc.
Digital Factory
Cypress, CA
Siemens PLM:
UG/NX Museum:
To an Engineer, the glass is twice as big as it needs to be.
John R. Baker, P.E.
Product 'Evangelist'
Product Engineering Software
Siemens PLM Software Inc.
Digital Factory
Cypress, CA
Siemens PLM:
UG/NX Museum:
To an Engineer, the glass is twice as big as it needs to be.
- Status
