Hello, I'm seeing a zinc diecast cylindrical rod failing (shearing off) prematurely (small moments applied). I had a composition analysis done, which showed the presence of the following materials, which aren't specified to be part of the alloy: Phosphorus (0.02%), Silicon (0.03%), and Tungsten (0.82%). In addition, the Aluminum and Copper content was also out of range (-1.54% and -0.1% respectively).
Do you think any of these deviations could cause the material to become brittle? I'd really appreciate any advice here!
Do you think any of these deviations could cause the material to become brittle? I'd really appreciate any advice here!
