Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Break view section in Drawing NX7.5

Status
Not open for further replies.

Weinstein

Industrial
Joined
May 21, 2013
Messages
14
Location
FR
Hello,

I'm trying to create a break view section of a projection view. my problem is that I can't select the chain of curves around my projection.

did this problem occur often and does anybody have a solution?

thank you very much in advance.
 
I guess you mean Break-Out Section View and not View Break.
If so, did you create your curves in the view? If you draw curves with sketch commands, did you select Activate Sketch View first? Or did you draw your curves directly on the Sheet?
 
Yes that's what I meant.
While in drawing I used the direct sketch tool to draw the curves.

I did skip the selection of the corresponding view, I did it now and it works very well. so thank you loads.
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top