Break in an auxiliary view

[mncad]

Is it possible to add a break to an auxiliary view? I have an auxiliary view that is rather long and I would like to break it, same as a horizontal or vertical, but I don't see any way to do it.

Thanks,
mncad

 

[Heckler]

Yes, I just did a break view on a Aux view. Insert > Drawing View there you will see the Hor/vert break. once you place those where you want them just RMB inside view and do select break view.

Best Regards,

Heckler
Sr. Mechanical Engineer
SW2005 SP 2.0 & Pro/E 2001
Dell Precision 370
P4 3.6 GHz, 1GB RAM
XP Pro SP2.0
NIVIDA Quadro FX 1400
o
_`\(,_
(_)/ (_)

Do you trust your intuition or go with the flow?

 

[mncad]

Heckler,

I had tried that on my drawing it won't allow it. Using SW2005 SP2.0. If I highlight the Auxiliary view first then Hor/vert break are greyed out in the menu, if I pick Hor/vert break first then the view it doesn't do anything. The view is off at an odd angle, does that have something to do with it?

Thanks,
mncad

 

[Heckler]

Hmmmmm, because I just did it both ways without any problems. Give me somemore back ground on this drawing.

Best Regards,

Heckler
Sr. Mechanical Engineer
SW2005 SP 2.0 & Pro/E 2001
Dell Precision 370
P4 3.6 GHz, 1GB RAM
XP Pro SP2.0
NIVIDA Quadro FX 1400
o
_`\(,_
(_)/ (_)

Do you trust your intuition or go with the flow?