Book Pro/Manufacturing

[batenceto]

Hello, I want to ask if he could recommend me some
literature on Pro / Manufacturing which is a higher level,
ie have described how the creation of MUDF, how to use CL
commands and more. things at a high level.
Thank you in advance.

regards
batenceto

 

[srieger]

Every book I've ever seen only covers the basics and maybe a few extra little things. I highly recommend the PTC courses for Pro/Manufacturing. Not only do they allow for in depth training but the people teaching thecourses are usually experience machinists and you can bounce issues and ideas of that person for real answers and ideas for solving it.


Myopinion is the price is money well spent.

 

[batenceto]

Thanks for the reply and advice, but none have any book
that has described step by step how to work with the
manufacturing module?

regards
batenceto

 

[srieger]

There is a book called:
<H1 =booktitle>Learning Pro/Manufacturing Using Pro/Creo Elements: </H1>
<DIV =booktitle>A Step-By-Step Guide to Learn Computer-Aided Manufacturing</DIV>
<DIV =booktitle></DIV>
<DIV =booktitle>I have never used it, reviewed it or seen it. So, I don't know how well it covers. My experience with previous books is that it only covers the a very small portion of the capabilities.</DIV>

 

[tgsp]

To the best of my knowledge, there are no good books out
there that go into details on manufacturing.
I taught Pro/E for over 10 years for PTC. They have scaled
down the courses to the ones that make money. I used to
teach milling, turning, wire EDM, and complex milling. All
these courses except the basic milling course have
disappeared, simply because there was not enough demand to
support the continuation of the courses. Your best bet
wold be to see if PTC still has an old complex milling
course book around, as that would give you some of the
information you are looking for.

 

[srieger]

Another option would be to get a PTC University course subscription.

 

[gbon]

Another option would be to get a PTC
University course subscription.

 

[Yodes42]

Another option would be to get different software

 

[srieger]

I believe it's about $1500 then around $200/year maintenance.

 

[batenceto]

Hello,

different software does not suit me because I develop PhD
thesis on post-processors for machines with two turret,
counter-spindle, multi tasking machines and therefore
looking for some books on the subject. I would be grateful
if you have something that would help me.

best regards
batenceto

 

[moriarty]

Have a look at www.proetutorials.com - $US350 is a good
price