Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Bolting material in service(e.g. sour, hydrogen..)

Status
Not open for further replies.
HOYA

HOYA

Mechanical
Joined
Jul 5, 2009
Messages
5
Location
KR

In selection of bolting material for heat exchanger in service environment. We generally use SA193-B7M&SA194-2HM instead of SA193-B7&SA194-2H.

I would like to know why SA193-B7M&SA194-2HM is preferred.

Thank you.
 
Sort by date Sort by votes
There are many discussions on this issue on this website. Use of B7M in sour service is per NACE RP0175. B7M has control on hardness, which is very important in sour service.
 
Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

abangbikerz
  • Question Question
lowest permissible temp for any material
Replies
3
Views
6K
abangbikerz
abangbikerz
WE.MetE
  • Locked
ASME - acceptable material editions
Replies
0
Views
1K
WE.MetE
WE.MetE
MicroEng
  • Locked
  • Question Question
RTJ Gasket manufacturing row material!
Replies
0
Views
1K
MicroEng
MicroEng
Tysoo2
  • Locked
  • Question Question
CO2 Piping service, Material Impact testing requirements.
Replies
5
Views
532
Tysoo2
Tysoo2
Jugaado Engineer
  • Locked
  • Question Question
Shaft service Life according to Standards
Replies
4
Views
526
geesaman.d
geesaman.d

Part and Inventory Search

Sponsor

Back
Top