Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Blow Down Vessel Sizing

Status
Not open for further replies.
Pavan Kumar

Pavan Kumar

Chemical
Joined
Aug 27, 2019
Messages
410
Location
CA
Hi All,

I am looking for guidance document/standard for sizing Blow down vessel for Heat Exchanger which used Boiler Feed Water on Shell side to cool process stream. The BFW converts to steam after heat exchange.
It would be helpful if some one can post the relevant pages of the standard so that I can develop an excel calculation spreadsheet.

Also is there any specification on the Height to Diameter ratio for vertical vessels. I have been hearing from people that that H/D should be between 1.5 to 2 for good design. Please reply.

Thanks and Regards,
Pavan Kumar
 
Status
Not open for further replies.

Similar threads

Pavan Kumar
  • Locked
  • Question Question
PSV Sizing On N2 Receiver Vessel
Replies
11
Views
2K
MortenA
MortenA
wd1980
  • Locked
  • Question Question
Back pressure in the blow down Valve
Replies
1
Views
522
LittleInch
LittleInch
Pavan Kumar
  • Locked
  • Question Question
Deaerator Sizing - Continued
Replies
12
Views
8K
TBP
TBP
Pavan Kumar
  • Locked
  • Question Question
Deaerator Sizing
Replies
10
Views
3K
Pavan Kumar
Pavan Kumar
Pavan Kumar
  • Locked
  • Question Question
Steam Mains Pressure Control Valve Sizing
2
Replies
28
Views
10K
pierreick
pierreick

Part and Inventory Search

Sponsor

Back
Top