I am having an issue with a couple of part numbers. Lines 3 and 4 have a dash and quote symbol in front of the numbered part and it is not intended. I have searched all the properties of the parts and everything looks good. The only solution I have found is to reinsert a new bill of material which corrects the problem.
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Bill of Material Error
- Thread starter gimpala
- Start date
I have not seen that before.
Did you check "all" custom properties of each configuration?
Chris, CSWA
SolidWorks '15
SolidWorks Legion
Did you check "all" custom properties of each configuration?
Chris, CSWA
SolidWorks '15
SolidWorks Legion
- Thread starter
- #3
Check to make sure if you are using just Custom Properties that the COnfig specific props are completely cleared out. I have found the same property in both areas causes conflicts in all areas of the Drawing including BOM's
Scott Baugh, CSWP![[pc2]](/data/assets/smilies/pc2.gif "[pc2] [pc2]")
Gryphon Environmental
Scott Baugh, CSWP
Gryphon Environmental
faq731-376
- Status
Similar threads
- Locked
- Question
- Question
- Question