I have a Shaft on 2 SKF bearings (6005 - Dia25/Dia47/12 and 6207 - Dia35/Dia72/17). Shaft is driven by a dyne at max speed 12,000 rpm. How to calculate the passage oil diameter (in housing) and the oil flow (l/min) for a correct lubrication of bearings ? Oil used is ATF.
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations MintJulep on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Ball bearings - Oil Flow Calculation
- Thread starter iucu
- Start date
For flow see:
(spreadsheet attached)
For diameter see:
Then I'd just do a quick Reynolds number to be sure you're well within the laminar range.
Hope that helps.
(spreadsheet attached)
For diameter see:
Then I'd just do a quick Reynolds number to be sure you're well within the laminar range.
Hope that helps.
- Status
Similar threads
- Question
- Locked
- Question