Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations LittleInch on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

B31.4 pig trap

Status
Not open for further replies.

Makun

Mechanical
Joined
Jul 20, 2009
Messages
57
Location
AR
Hi fellows, I'm doing a revision of the design of a pig trap (B31.4) and I can't find in the code if this kind of component needs a special desing factor. Could I design a pig trap with F=0.72?.

Regards

 
You can, if you don't need less. The B31.4 code states that the maximum design factor cannot be more than 0.72. It allows, but doesn't specify a minimum.[ul]
[li][/li]
[/ul]

I hate Windowz 8!!!!
 
Hi BigInch, thanks for the answer. I was looking a reference inside the code about pig traps... but I didn't found it.

Regards and I hate windows 8 too
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top