If a welder takes a plate-groove test in the 3G & 4G positions would he also be qualfied to weld pipe or tubing? Table 3.7 indicates that pipe positions flat for groove and flat & horizontal for fillet are qualifed but table 3.8 has no reference to the diameter limitations.
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
aws d1.2 welder qualification
- Thread starter cjgrass
- Start date
- Status
Similar threads
- Locked
- Question
- Locked
- Question
- Locked
- Question