jeremywelch
Electrical
I have been working on schematics that include a lot numbering of pages and I am looking for a way to do this automatically. i am using AUTOCAD 2002!
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations JAE on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Auto page numbering
- Thread starter jeremywelch
- Start date
- Status
Do the actual drawing file names have the number in it? If they do, you could pull from them with a routine. If these are different layouts within a single drawing, then you would have to do it with some sort of routine based on which layout it is. AutoCAD also automatically calls blank drawings Drawing1, then Drawing2, etc.. then you could rename. Just throwing out some ideas..
"Everybody is ignorant, only on different subjects." — Will Rogers
"Everybody is ignorant, only on different subjects." — Will Rogers
I found this:
ADT 2004
ACAD 2002
ADT 2004
ACAD 2002
- Status
Similar threads
- Locked
- Question
