I am currently analysing an attic truss rafter as a single 2-D frame frist in SAP2000 step 2 is to replicate as a roof structure. my problem lies with applying end releases to the members. When i release major; minor moments and torsion to simulate a pin the frame fails the sap analysis. What am i doing wrong
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Attic truss analysis
- Thread starter acsavo
- Start date
- Status
Similar threads
- Locked
- Question
