Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

associative Spline poles extraction

Status
Not open for further replies.
TCMartist

TCMartist

Marine/Ocean
Jun 20, 2006
21
hi everyone,

just to have confirmation by the experts on this forum: as far as I know, there is no way to extract spline poles associatively nor to snap on them, is there?

thanks in advance.

FYI: I use NX4
 
Status
Not open for further replies.

Similar threads

2_BIG
  • Question
Filename Extraction
Replies
1
Views
3K
cowski
cowski
SSO Contractor
  • Question
Distance Measure within an active command i.e., Extrude, Pattern etc. is no longer associative?
Replies
4
Views
4K
jimiherf
jimiherf
mery0
  • Locked
  • Question
mirror spline the spline created
Replies
0
Views
201
mery0
mery0
formatt
  • Locked
  • Question
Associative Angle in WCS XY plane (or others) NXv11
Replies
3
Views
281
Toost
Toost
jmarkus
  • Locked
  • Question
NX Drafting Journal - Identify Location of Spline on Drawing Sheet 1
Replies
2
Views
276
jmarkus
jmarkus

Part and Inventory Search

Sponsor

Back
Top Bottom