jeffroot
Mechanical
- Sep 5, 2006
- 27
I want to put some pockets in an assembly (a 2 piece weldment).
Sounds easy enough right?
Heres my catch, I need to have radiused edges on the bottom of the pocket - as if it were cut by a radiused endmill. I need this so I can accurately represent the goemetry when I run this model through cosmosworks.
Working this feature into the assembly model appears to be pretty hopeless (correct me if I am wrong), so I am considering saving the assembly as a part and then adding these features in the part file.
My question: Is there a way to save an assembly as a part, but have the part be updated if the assembly geometry is changed??
Sounds easy enough right?
Heres my catch, I need to have radiused edges on the bottom of the pocket - as if it were cut by a radiused endmill. I need this so I can accurately represent the goemetry when I run this model through cosmosworks.
Working this feature into the assembly model appears to be pretty hopeless (correct me if I am wrong), so I am considering saving the assembly as a part and then adding these features in the part file.
My question: Is there a way to save an assembly as a part, but have the part be updated if the assembly geometry is changed??