Assembly Constraints, cannot center a cylinde to anoter cylinder

[Bogdan1985]

Hi,

a new surprise in the morning. I have a railing post which should be centered to a hole in the floor.
All of the sudden I cannot touch/align/ center line to centerline. And even not face touch to face.

A coworker says its something with the save options. Which are the correct save option combination to get it back?

Thx

 

[cowski]

You can open the assemblies constraints command, but not select anything? If so, check your selection filter setting and selection priority.

www.nxjournaling.com

 

[jerry1423]

Make sure the two components are fully loaded (not just partially).

Jerry J.
UGV5-NX11

 

[Bogdan1985]

Thank you Cowski and Jerry1423.

You both are right. But I could neither change the priority nor the load options.

I reinstalled NX and it works now. Everyday a new surprise!

Thanks again.

 

[PSI-CAD]

Hi,
Be carefull with load options on your site.
May be the file load_options.def is shared by another colleague. So you problem could appeared again

Regards
Didier Psaltopoulos

http://www.psi-cad.fr