Hello, I have created an assembly with expressions at the top level of the model area - infact just a list of values - that drive the creation of the parts below. I want to use this as the starting point for the creation of custom assemblies. The problem is, when I clone the assembly the parts with the interpart expressions still point to the ORIGINAL file rather than the cloned parent. I have tried a few options and read the post on here but have drawn a blank - any ideas?! Many thanks.
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Assembly cloning WITH interpart expressions...
- Thread starter merlinski
- Start date
