I am checking an existing exchanger for a new application (slightly superheated steam on shell, liquid on tube side). After inputing the exchanger's information, if I run it in "simulation" mode I get only 60% of the steam condensing vs. if I run it in "ratings" mode 100% of steam condenses. Anyone familiar enough with B-JAC to tell me why?
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
ASPEN B-Jac
- Thread starter jlippe
- Start date
- Status
Similar threads
- Locked
- Question
- Locked
- Question